Delila Program: bndrec

bndrec program

Documentation for the bndrec program is below, with links to related programs in the "see also" section.

{version = 1.05; (* of bndrec.p 2000 March 27}

(* begin module describe.bndrec *)
   bndrec: create marks file for a boundrectangle

   bndrec(bndrecp: in, bndmarks: out, output: out)


   bndmarks:  The marks for the lister program.  Concatenate this
      to the end of the marks.arrow file and put the result into the marks
      file for lister.

   bndrecp:  parameters to control the program.  The file must contain the
      following parameters, one per line:

      parameterversion: The version number of the program.  This allows the
         user to be warned if an old parameter file is used.

   output: messages to the user


   It is somewhat difficult to write the specific corners of boundrectangles
   as defined in marks.arrow.  This program takes a simple parameter file
   and creates the user defined marks.


   The boundrectangle is called this way:

U   4000.0   -12.00    4019.0    -11.00       -217 boundrectangle

U says to lister to start working on a user defined mark
4000 is the left edge of the mark in bases
 -12 is the lower edge of the mark in bits
4019 is the right edge of the mark in bases
 -12 is the upper edge of the mark in bits
-217 is how far back the rectangle should be shifte in bases

The bndmarkp file creates this from:


see also

   program that uses marks lister.p

   definition of boundrectangles: marks.arrow this MUST be before
   the bndmarks from this file.


   Thomas Dana Schneider


technical notes

(* end module describe.bndrec *)
{This manual page was created by makman 1.45}

{created by htmlink 1.62}
U.S. Department of Health and Human Services  |  National Institutes of Health  |  National Cancer Institute  |  | 
Policies  |  Viewing Files  |  Accessibility  |  FOIA